Skip to content

Bowser Boss Command Block for Minecraft 1.8

Boss fights in Minecraft can be pretty entertaining, but once you’ve beaten the Wither or a Netherdragon a couple of times, the event loses its appeal. Even the new aquatic bosses which appear in underwater temples are starting to become boring as players figure better and faster ways to kill the things. The bowser Boss command block will add to Minecraft a special fight against the iconic villain from the Super Mario Brothers series. Just like you might imagine, Bowser is big, bad and full of fire. The first few times you face him, you should expect to take a beating.


View preview:

But regardless of how much fun a command block can be, it won’t work if you don’t actually have the command to feed into the block. So head to the official website (below) to get the command, then just copy it and paste it into the command block back in Minecraft. The Bowser Boss fight is a pretty tough one, so you might want to bring along a friend or two to give you a hand. On death, the big dinosaur drops some super-powered gear that any Minecraft player would love to have, so the whole thing is worthwhile. But it’s also very difficult.

How to install Bowser Boss Command Block for Minecraft?

  • Setup 1 – The first command you can run is:

/give @p minecraft:command_block

  • Setup 2 – Next, place it and paste the following command inside it.
  • Setup 3 – After you have finished copied all the commands, run the command block with a Redstone block.


Credit: TheRedEngineer

Leave a comment / review

All reviews and comments must follow our policy in order to be approved.

Your email address will not be published. Required fields are marked *